Put the watch on without adjusting it. You will need to note how big the watch is.

· If the watch is very loose, you will have to remove lots of links.

· Find the clasp and Pinch the band evenly from the clasp until it is the proper size.

· Make sure you have an equal number of links on either side of the clasp that need to be removed.

· This will make sure the watch itself stays centered on the wrist band.

· Write down the number of links that need to be removed from either side of the clasp.

· Get your adjustment tool, to push out the pin holding the wristband link in place.

You want to push from the (same arrow) direction as shown on the watch.

· Push the sharp end of the pushpin against the head of the link pin.

· A small amount of the push pin should now be protruding from the other side of the link.

· Pull the pins out and repeat the entire process on the other side of the wrist band.

· Re-Attach the clasp back onto the wrist band. Line up the link on the clasp with the last link on one side of your wristband.

· You should see a clear hole where a pin should go to hold the clasp on.

· Take one of the pins you removed and insert it into this hole.

· It should go most of the way in on its own, except for the last little bit on the end.

· Use the adjustment tool and turn the nozzle in a clockwise direction until you firmly push the pin in place. NOTE ; the pin shouldn’t be protruding at all and should be flush with the side of the watch.

· Repeat this process on the other side of the clasp.